Masternodes, Stream different

@admin any updates on the Masternode movie?

The movie is ter russian language, hope someone could translate it with subtitles.

And here is a textual manual (yet te russian, use Google translator) compiled from the movie above.

you got Two Knots with the same settings I’d guess!

delete and embark overheen!

@azu Now different error, why? )

  1. How to zekering MN and unlock coins for werkstaking only (MN not running well)?
  2. How to run Two MN at the same time? Config masternode.conf with Two MN gegevens, onberispelijk?

Good day. Problems with MN.

For no apparent reason, it stops every 70-80 minutes. I did not find anything suspicious ter the logs.

<, No problems were found

Spil soon spil I notice that the MN is stopped, I press ",commence",, after which it starts without problems and raises again 70-80 minutes, then the situation repeats.

On this same server, the MN works for 8bit coin, with it there are no such problems.

Can you give advice on how to embark looking for a problem, or is it not a problem for mij?

When MH stops began, I attempted the following:

Eliminated Bitradio-QT, installed the Bitradiod, disconnected LXDE,

But the situation has not switched.

Bitradio version v1.0.0.0-61402

uname -a: Linux raspberrypi Four.9.24-v7+ #993 SMP Wed Apr 26 Legal:01:23 BST 2018 armv7l GNU/Linux

MasterSata 92.54.74.91:32454 XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX X

Sorry for bad english – google translate

I response my own question.

It turned out that Bitradiod on the server abruptly stops, and silently.

Then it is not clear how the MN starts, but starts and starts production.

Spil a improvised solution, the script checks if the process is running, if not, then it starts.

@azu Now different error, why? )

I have a similar problem with this one.

My MN worked. I rebooted the PC where it worked. After the reboot, I did not touch anything and did not switch anything. Just launched a bitradio on a remote server.

Now on my local PC shows the following:

MN 82.117.253.185:32454 Not ter the masternode list

When I press button ",commence", – shows mij a message: ",Error: could not allocate zwemvlies",

If I run through the console with the guideline ",masternode commence",

shows mij a message: ",you voorwaarde set masternode=1",

But once again I repeat, I did not touch anything anywhere and did not switch it, just rebooted the PC.

Related movie: BitConnect Man MEME COMPILATION


Leave a Reply